M8 hex screw cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This model covers the sharp corners and edges of a hex screw installed. It was designed to be installed on a kids toy.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 75
- Wydruki
- 0
- Wyświetlenia
- 483
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This screw cover was inspired by the repair of a kids table soccer. The screw heads stick out on the side and children might injure themself. This cover is designed to be relatively smooth, for a FDM printed part, to make the table safer.
The channels/holes on the bottom can be used to lift the cap of with a small screw driver.
Please check before printing:
- Measure your screw head incl. the washer to check this model fits.
- You should check the tolerances of your printer to ensure a snug fit on the screw head.
- Material shrinkage might effect the snug fit as well.
Print instructions:
- Adjust the size of the screw cover by scaling in the slicer for a snug fit
- Filament of your choice
- 0,2 mm layer height (or lower for extra smoothness)
- Supports needed for the inner overhangs
I would be happy to see some of your makes posted :)
Source files in the Alibre Atom format is available but the website does not allow the upload. If you need it send me a message.