Opentrons OT-2 Top Window Hold Down Clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple clip that pushes OT-2 top window down onto window sensor. Fixes sensors that are not aligned properly
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 148
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Share Alike
Opentrons OT-2 Top Window Hold Down Clip
Disclaimer
I do work for Opentrons. But this is not an officialy approved solution. Just allowed me to keep testing the robot.
Description
The sensor on my OT-2, that detects if the top window is installed, is not making contact with the top window. This clip slides between the window and the aluminium frame, bending the window to make contact with the sensor.
Slicing
Sliced with Bambu Studio, everything is default unless otherwise specified.
Settings:
Layer Height: 0.2mm
Wall Loops : 3
Top Shell Layers: 3
Top Shell Thickness: 0
Sparse Infill Density: 30%
Sparse Infill Pattern: Gyroid
I printed with no brim because the PEI plate of the Bambu P1S has excellent adhesion. But it is possible that you might need to add one if you have adhesion issues.
Installation
The clip should be slid as far as possible to the front left side of the robot.
The easiest way to install this is to push the clip on in the center of the left side of window. Then slide it to the front.