1 / 10
AOS 3.5: O3 and ELRS antenna holder with XT30 hard-mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a 2 part O3, ELRS and XT30 combo holder for the AOS 3.5 v2, and likely the newer AOS 3.5 EVO, frame.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 789
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 1)Remiksy (1)Kolekcje (10)Powiązane
This is a 2-part design
Part 1 - Antenna holder for a small ELRS T-style antenna. It's likely others will fit just fine.
- Attach the antenna with cable ties
- The antenna is meant to fit partially under the main bottom frame and the bracket that holds the arms together.
Part 2 - O3 Antenna holder and hard mount for a XT30 receptacle (socket?).
- The XT30 is glued in with CA (Cyanoacrylate) superglue
- there are slots for the O3 antenna leads, so the antenna can remain connected to the O3 Air Unit while the holder can be taken off.
It's intended to print it in PLA, I haven't flown it to hard yet, but it should hold up. Else print it in TPU.
Printed on a BambuLab X1C with 0.4 mm nozzle and 0.2 mm layer height.