1 / 2
Bowden Tube Y-Splitter with PC4-M6 Connections and Attachment — zdjęcie 1
1 / 2

Bowden Tube Y-Splitter with PC4-M6 Connections and Attachment

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Allows to use Bambu Lab's AMS with external filament.

Ocena
4,667 / 5
Polubienia
29
Pobrania
408
Wydruki
5
Wyświetlenia
1591
Oceny
6

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Print with ABS or PETG with brim and no support (only touching print bed). You need to rotate the model so that the single entry is at the bottom. Don't use too much force when screwing in the PC4-M6's. Fully push the bowden tubes through the PC4-M6's.

You must use “UNLOAD” when removing the external filament, not manual retract. This will give the filament a clean cut and it will not stuck in the splitter.

See also: https://www.printables.com/de/model/584189-clean-bowden-y-splitter

 

Tagi