1 / 4
Chain Pull Fob for Shop Light; Large Size, Glow-in-the-Dark — zdjęcie 1
1 / 4

Chain Pull Fob for Shop Light; Large Size, Glow-in-the-Dark

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a chain pull fob for shop light fixtures, which have a traditional pull chain. It is larger than most pulls.

Ocena
5 / 5
Polubienia
20
Pobrania
104
Wydruki
4
Wyświetlenia
467
Oceny
4

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Home Decor
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a chain pull or fob for shop light fixtures that have a traditional pull chain. It is larger than most pulls, so that it is easier to grab while wearing gloves. It will fit on most light fixture pull chains that have an existing pull. The chain must have some type of larger bell, ball or connector on the end, which acts as a stop to hold the chain pull in place. This pull will extend the length of an existing chain pull by ~25 mm. See the attached diagram for dimensions; this diagram shows the type of pull chain and end bell that is on my shop lights, and which are the basis for my design of this chain pull design.

I printed them in glow-in-the-dark PLA. Supports are not necessary. Build plate adhesion is not required, but I printed mine with a 3-line brim (inside & outside), just in case; clean-up was very easy. I printed 8 of these pulls, one at a time, and they all printed really well.

Tagi