Chain Pull Fob for Shop Light; Large Size, Glow-in-the-Dark
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a chain pull fob for shop light fixtures, which have a traditional pull chain. It is larger than most pulls.
- Rating
- 5 / 5
- Likes
- 20
- Downloads
- 104
- Makes
- 4
- Views
- 467
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a chain pull or fob for shop light fixtures that have a traditional pull chain. It is larger than most pulls, so that it is easier to grab while wearing gloves. It will fit on most light fixture pull chains that have an existing pull. The chain must have some type of larger bell, ball or connector on the end, which acts as a stop to hold the chain pull in place. This pull will extend the length of an existing chain pull by ~25 mm. See the attached diagram for dimensions; this diagram shows the type of pull chain and end bell that is on my shop lights, and which are the basis for my design of this chain pull design.
I printed them in glow-in-the-dark PLA. Supports are not necessary. Build plate adhesion is not required, but I printed mine with a 3-line brim (inside & outside), just in case; clean-up was very easy. I printed 8 of these pulls, one at a time, and they all printed really well.