Vinyl Siding Mounting Block
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple mounting block for vinyl siding for mounting a doorbell or whatever else you might.
- Ocena
- 0 / 5
- Polubienia
- 26
- Pobrania
- 364
- Wydruki
- 0
- Wyświetlenia
- 1856
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
My new Ubiquiti G4 Doorbell Pro was significantly larger than the older model it replaced so a new mounting plate was required. I wanted a simple mounting plate that allowed me to locate the doorbell optimally. My house has vinyl siding with a 4.5" reveal, so I threw together this model to provide a simple flat base. Note that I intentionally included a slight curve on the sides to fit tightly to the siding.
As this covers two rows of siding it is nearly 9" long (223 mm) so you're going to need a larger bed to print flat. The 3MF I attached printed the first layers at .3mm then transitions to .1 to optimize for the curved and angled sides.
As I wanted the ultimate flexibility, I did not place the holes from the doorbell mounting plate. These are easy to add with negative volumes in PrusaSlicer, of course, or just drill it like I did.
The attached images show the final product installed on my [very dirty] house. I printed in Prusament PETG since this is entirely covered and sees no direct UV or weather, but your mileage may vary.