Prusa Mini Z-axis support
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Z-axis support for Prusa Mini/Mini+ printer
- Ocena
- 4,887 / 5
- Polubienia
- 674
- Pobrania
- 2708
- Wydruki
- 103
- Wyświetlenia
- 15 289
- Oceny
- 97
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Support for z-axis of Prusa MINI printer. Inspired by https://www.prusaprinters.org/prints/51415-prusa-mini-z-axis-brace/.
You will need:
- 6pcs M5x12 ISO 7380 bolt (https://www.ebay.com/itm/232247392111)
- 6pcs M5 t-nuts
Print instuctions:
Print with side that is attached to z-axis facing down. Use at least 20 % infill. Supports are needed under y-carriage side mount (see picture below).
Installation:
First, put bolts through holes and hand-tighten t-nuts and align them as on photo below. Leave out holes that are on top of Y-axis.
Now place z-axis support on top of Y-axis and slide t-nuts in mounting profile.
Continue with sliding it towards the Z-axis.
Loosen all bolts a bit so that they can lock in the profile and tighten them firmly.
Last step is to place t-nuts inside top of Y-axis and thighten last two screws.
And you are done.
