1 / 3
Polaris/Zodiac/Caretaker 99 in-floor pool cleaner spring retainer — zdjęcie 1
1 / 3

Polaris/Zodiac/Caretaker 99 in-floor pool cleaner spring retainer

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Save $65+ by replacing corroded spring in a Polaris/Zodiac/Caretaker 99 swimming pool jet, instead of buying a new unit!

Ocena
0 / 5
Polubienia
5
Pobrania
32
Wydruki
0
Wyświetlenia
622
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Field tested for nearly 3 years! Still working well underwater in either PLA or ABS.

When an in-floor pop-up Caretaker 99 swimming pool cleaner no longer retracts and rotates, then the spring has probably corroded. Why spend $80-$100 on a new unit when you can spend $15 on a new spring and print a new retaining cap?

I made this for a client whose swimming pool has several Caretaker 99 threaded cleaning heads that stopped working because the springs failed. All of the Caretaker models seem to have a common end cap and spring, so this design should be compatible with all models.

Eventually the entire pop-up-and-rotate mechanism wears out, requiring replacement of the whole unit, but this repair extends its life significantly.

Replacement spring

Here is the compatible spring: https://www.leespring.com/compression-springs?search=LP059S01S316

Its diameter is a fraction of a millimeter larger than the original spring, and it has a slightly higher load resistance, but it has been working well after years of operational use in multiple repaired cleaning heads.

Printing

Print settings: 3 perimeters, 0.2 mm layers, solid infill.

Material: Anything that sticks to epoxy or Gorilla glue. ABS is preferred, but PLA works.

Printing takes 32 minutes on a Prusa MK3S.

I printed some in PLA and some in ABS. Both materials have worked well without failure. I was surprised that PLA would last so long underwater.

Repair instructions

  1. To remove the old spring, you must break or grind the bottom cap off the unit (it is glued in place).
  2. Pull out what's left of the old spring.
  3. Where the old glue used to be, abrade the surface of the Caretaker unit with sandpaper.
  4. Insert the new spring.
  5. Glue on the new cap using epoxy or Gorilla glue.
  6. Allow the glue to cure before installing the repaired unit underwater.

PVC glue fails to stick well to the Caretaker unit, causing the spring to eject the cap eventually. I believe the Caretaker 99 is made from ABS, so ABS glue should work too, especially if you print this cap with ABS. 

Tagi