Polaris/Zodiac/Caretaker 99 in-floor pool cleaner spring retainer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Save $65+ by replacing corroded spring in a Polaris/Zodiac/Caretaker 99 swimming pool jet, instead of buying a new unit!
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 32
- Makes
- 0
- Views
- 622
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Share Alike
Field tested for nearly 3 years! Still working well underwater in either PLA or ABS.
When an in-floor pop-up Caretaker 99 swimming pool cleaner no longer retracts and rotates, then the spring has probably corroded. Why spend $80-$100 on a new unit when you can spend $15 on a new spring and print a new retaining cap?
I made this for a client whose swimming pool has several Caretaker 99 threaded cleaning heads that stopped working because the springs failed. All of the Caretaker models seem to have a common end cap and spring, so this design should be compatible with all models.
Eventually the entire pop-up-and-rotate mechanism wears out, requiring replacement of the whole unit, but this repair extends its life significantly.
Replacement spring
Here is the compatible spring: https://www.leespring.com/compression-springs?search=LP059S01S316
Its diameter is a fraction of a millimeter larger than the original spring, and it has a slightly higher load resistance, but it has been working well after years of operational use in multiple repaired cleaning heads.
Printing
Print settings: 3 perimeters, 0.2 mm layers, solid infill.
Material: Anything that sticks to epoxy or Gorilla glue. ABS is preferred, but PLA works.
Printing takes 32 minutes on a Prusa MK3S.
I printed some in PLA and some in ABS. Both materials have worked well without failure. I was surprised that PLA would last so long underwater.
Repair instructions
- To remove the old spring, you must break or grind the bottom cap off the unit (it is glued in place).
- Pull out what's left of the old spring.
- Where the old glue used to be, abrade the surface of the Caretaker unit with sandpaper.
- Insert the new spring.
- Glue on the new cap using epoxy or Gorilla glue.
- Allow the glue to cure before installing the repaired unit underwater.
PVC glue fails to stick well to the Caretaker unit, causing the spring to eject the cap eventually. I believe the Caretaker 99 is made from ABS, so ABS glue should work too, especially if you print this cap with ABS.