1 / 5
Canon 10x42 L IS WP binocular lens caps — zdjęcie 1
1 / 5

Canon 10x42 L IS WP binocular lens caps

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement design for lens caps of Canon 10x42 L IS WP binoculars

Ocena
5 / 5
Polubienia
10
Pobrania
67
Wydruki
3
Wyświetlenia
525
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Attribution — Share Alike

Canon's 10x42 L IS WP binoculars are wonderful binoculars but the lens caps provided are terrible. They're difficult to put on and come off way too easily. They also come with a lanyard which is supposed to make them easily useable, but the lanyard gets tangled in the neck strap. For a premium pair of binoculars I would expect more thought from Canon in the design of their lens caps.  I designed these caps to hinge at the top of the objective so that you can easily use them. This is a first iteration. You'll need to cut two small lengths of filament to use as hinge pins.

April 2024 -  new version! 

I started from scratch and designed a new version which addresses the things I didn’t like about the original design. 

  1. The hinge pin was a little too difficult to install and you could not adjust the tension. I ordered some M2 x 30 mm screws from Amazon and now the hinge is perfect.
  2. The cap fit flush with the base. There was no way to hold it in a closed position. I created some overlap between the caps and the base to solve this.
  3. I also made the base 1mm thicker and adjusted the tolerances for a snug friction fit.

It’s probably best to print with PETG. I used a 0.15 layer height and 25% infill with the MK4 presets. There are no supports required to print this.