Canon 10x42 L IS WP binocular lens caps
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement design for lens caps of Canon 10x42 L IS WP binoculars
- Rating
- 5 / 5
- Likes
- 10
- Downloads
- 67
- Makes
- 3
- Views
- 523
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Share Alike
Canon's 10x42 L IS WP binoculars are wonderful binoculars but the lens caps provided are terrible. They're difficult to put on and come off way too easily. They also come with a lanyard which is supposed to make them easily useable, but the lanyard gets tangled in the neck strap. For a premium pair of binoculars I would expect more thought from Canon in the design of their lens caps. I designed these caps to hinge at the top of the objective so that you can easily use them. This is a first iteration. You'll need to cut two small lengths of filament to use as hinge pins.
April 2024 - new version!
I started from scratch and designed a new version which addresses the things I didn’t like about the original design.
- The hinge pin was a little too difficult to install and you could not adjust the tension. I ordered some M2 x 30 mm screws from Amazon and now the hinge is perfect.
- The cap fit flush with the base. There was no way to hold it in a closed position. I created some overlap between the caps and the base to solve this.
- I also made the base 1mm thicker and adjusted the tolerances for a snug friction fit.
It’s probably best to print with PETG. I used a 0.15 layer height and 25% infill with the MK4 presets. There are no supports required to print this.
