QIDI X-Smart 3 Side Spool Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Side Spool Holder due to space constraint at the back.
- Ocena
- 4,833 / 5
- Polubienia
- 54
- Pobrania
- 424
- Wydruki
- 11
- Wyświetlenia
- 1456
- Oceny
- 12
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Hi all,
Due to space constrain in the office, I had to mount the filament on the side.
Just looking around for spool holders and thought i should just practice 3d modeling and use the mount from another designer.
2 type of spool holder
Using the original holder or another by itself.
Print it flat down (with tree/organic support for the holder that uses the original holder.
Do use a pcs of rubber or foam tape to hold it in place
Also use a PTFE tube to guide the filament without the two, there may be some feeding issue.
Print setting as you prefer.
Setting I used:
E220 B60
0.2mm Layer Height
15% infill, Grid
3 wall, 4 Top and 3 Bottom.
Thank you for viewing!