1 / 8
West Marine Transom Saver yoke repair (2 parts) — zdjęcie 1
1 / 8

West Marine Transom Saver yoke repair (2 parts)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Wstępna wycena dla PETG

9,95 € – 12,16 € netto (bez VAT)

Dla pliku: motor holder_0.4n_0.3mm_PETG_MK3S_9h33m.gcode

To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.

Plik i założenia wyceny

Plik użyty do wyceny

Średnia wycena orientacyjna: 11,06 € netto (środek widełek).

Masa podana przez autora
182 g
Czas druku podany przez autora
9,55 godz.
Materiał u źródła
PET
Materiał wyceny
PETG
Drukarka wyceny
Bambu Lab P1S - 0.4 nozzle
Proces wyceny
0.20mm Standard

Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.

Zapisane na tym urządzeniu.

A transom saver absorbs shocks while moving your boat by a trailer. This part is the yoke that holds the motor securely.

Ocena
0 / 5
Polubienia
4
Pobrania
30
Wydruki
0
Wyświetlenia
378
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This model contains two parts - one is the motor yoke to hold the motor, and the other is an insert (print in TPU) that provides some grip and shock transmission.  My West Marine transom saver had fallen down and dragged the road - and the yoke was no more when I found out what had happened (the original part was a pile of aluminum dust on the road, but it's similar to the yoke that I designed).  A new one costs over $70 at the store - so I designed a new yoke and added a way to use bungies to keep it from dragging on the road again.  A picture of the original is in the pictures section.

The yoke and pad are both easy prints.  No supports are required for either.  Print the yoke in a strong material (PC blend would be best) - as my draft printed in PETG is strong enough for the road, but if you drop it on the ground it can break.   Print the round insert in a TPU - then insert it into the yoke as part of assembly.  Then just put the bolt through the hole in the transom saver arm, and tighten it down.  Pictures show how it fits a 20HP honda lower unit, and with bungee attached.

To increase the strength of the part, I chose 10 perimeters, and 50% gyroid infill, with seam set to “Rear” - with the part positioned Y opening to the rear of the bed.  An all TPU yoke would be another good option to prevent future breakage and give a bit more shock absorption.