West Marine Transom Saver yoke repair (2 parts)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A transom saver absorbs shocks while moving your boat by a trailer. This part is the yoke that holds the motor securely.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 30
- Makes
- 0
- Views
- 378
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution
This model contains two parts - one is the motor yoke to hold the motor, and the other is an insert (print in TPU) that provides some grip and shock transmission. My West Marine transom saver had fallen down and dragged the road - and the yoke was no more when I found out what had happened (the original part was a pile of aluminum dust on the road, but it's similar to the yoke that I designed). A new one costs over $70 at the store - so I designed a new yoke and added a way to use bungies to keep it from dragging on the road again. A picture of the original is in the pictures section.
The yoke and pad are both easy prints. No supports are required for either. Print the yoke in a strong material (PC blend would be best) - as my draft printed in PETG is strong enough for the road, but if you drop it on the ground it can break. Print the round insert in a TPU - then insert it into the yoke as part of assembly. Then just put the bolt through the hole in the transom saver arm, and tighten it down. Pictures show how it fits a 20HP honda lower unit, and with bungee attached.
To increase the strength of the part, I chose 10 perimeters, and 50% gyroid infill, with seam set to “Rear” - with the part positioned Y opening to the rear of the bed. An all TPU yoke would be another good option to prevent future breakage and give a bit more shock absorption.