Headphone Hanger Spacer for Ikea Alex Desk
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small spacer block for use on an Ikea Alex desk, as the pole legs are too thin for most headphone hangers
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 270
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
A simple, easy to print, reliable spacer bracket for Ikea Alex Desks.
I needed to add a headphone hanger to the leg of the Ikea Alex desk, but the thin legs proved to be too narrow for the hanger brackets. As such, I designed this model to provide a larger surface area onto which the headphone hanger can clamp.
If you have an Ikea Alex desk where you would like to mount a Headphone Hanger clamp, then this model is perfect for you!
This model is an easy print which requires no supports.
The model is also available at OnShape.
Please note that the Ikea Alex desk leg is modeled in this design, you don't need to print that part!
This model requires 3 heat-set inserts, sized for M3 screws.
Two will hold the front of the spacer block on to the rest of the model, and one is meant to be used as a ‘set screw’/'grub screw' to hold the block in place and prevent it from sliding down the desk leg.
Recommended Print Setup:
I recommend printing in PETG, as it will ensure that the model is a bit more resistant to heat and flex, but PLA might work fine too.
I've provided a PrusaSlicer file (*.3mf) which contains a number of suggested print options, but to highlight relevant parts here:
- (At least) 3 perimeters - I used 4
- 15% infill - Higher infill will ensure the clamp doesn't flex.
- 0.2 mm Layer Height