Pocket case for 50 mm screwdriver bits
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for 12 1/4 inch screwdriver bits.
- Ocena
- 4 / 5
- Polubienia
- 27
- Pobrania
- 125
- Wydruki
- 2
- Wyświetlenia
- 542
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Secure flat case for 12 50 mm long ¼ inch screwdriver bits. Insert clicks in place after pushing it in the case. Squeeze the sides of the case to release.
PETG recommended for its flexibility. Depending on your printer tolerances the “buttons” on the case might need some releasing with a hobby knife. Don't push too hard if the insert is not in or you might snap one off. Make sure the insert slides freely inside the case. If it takes too much force to push the buttons to release you can trim the locking nubs on the sides of the insert down until it's right for you.
STEP file included.