LED Snowflake Bracket for Square Railings
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution
I created this bracket to securely mount the LED Snowflake by @hoangnam to the front of my porch railings, which are 35mm squares.
Slide 2 arms of the flake (top and bottom) into their respective mounting brackets. These are meant to fit TIGHT, so expect to have to use a little force to spread the bracket open while sliding onto the flake.
Each flake uses 2 of these brackets, and once mounted to the railings, grab tight and do not slip at. Best of all, they're simple to install and remove from the railings without the need for drilling or using screws. I'd recommend leaving the brackets on the flakes when storing them for the off-season.
###*** See attached images for dimensions
Credits:
Snowflake Designer: hoangnam: https://www.thingiverse.com/hoangnam/designs
Snowflake design: https://www.thingiverse.com/thing:1966885
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
Standard - 0.2mm
Infill:
Yes - 20%
Filament: Comgrow PLA White
Notes:
PLA might not be best for use here, but it's all I had at the time, and stood up to some hard winter days this season without any noticeable issues.
Category: Props