Miniature Director's Chair
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Miniature director's chair, printable without supports as an authentic torture test.
- Ocena
- 5 / 5
- Polubienia
- 164
- Pobrania
- 871
- Wydruki
- 1
- Wyświetlenia
- 2478
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props & Terrains
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Miniature director's chair.
Printable without supports and in two colors by simply changing the filament (in height) in the 2 fabric areas.
The original size is: 73mm (height) x 47mm (width) x 35mm (depth).
You can use supports or accept the challenge and do it without them.
This will push your printer (and your patience XDD) to the limit.
Overhangs, bridges, retractions, thin columns, adhesion, z-jumps and color changes are some of the challenges your printer will have to overcome to get this chair printed.
Recommendations:
Small layer height (0.15 or less), lower the speed (except for bridges), add a lot of brim (to increase adhesion), increase the z-lift/hop (to avoid collisions).
Good luck .... and have fun.
