Metro rack 3/4" dowel stabilizer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Allows running a pair of 3/4" dowels across the width of a metro rack for use storing filament spools.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 181
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- BSD License
I wanted to create a filament storage space in a metro (wire shelf) rack, with minimal materials. This metro rack is from Costco, and has wires running from front to back that I measure as 3.67mm thick, with a 16.2mm gap between wires. Make sure yours are the same, or adapt the width and spacing of the gaps.
Using four of these, I can support two ends of two ¾" dowels, running in parallel for 24", which filament rolls can sit on - without falling into the wire rack.
I printed mine in PETG, to be a bit less brittle but I'm sure this would work in PLA as well. When assembling, slide the dowels in from the end - even using PETG, you're likely to break the print if you force the dowel in from the top.
I printed these open-face downwards, with no support material. In PETG it resulted in a bit of stringing inside - but that area will be hidden by the dowel and loose strings are easily scraped out with any convenient tool so the dowel insertion isn't obstructed.
Different approach to https://www.printables.com/model/188079-filament-shelf-rod-adapter