1 / 5
"Ender 3 NG - coreXY" to ApolloLander (dual 5015 fans) interface ~ prototype — zdjęcie 1
1 / 5

"Ender 3 NG - coreXY" to ApolloLander (dual 5015 fans) interface ~ prototype

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Single piece replacement (ApolloLander not included) Adds 4 mounting point matching an MGN12H pattern 20x20mm

Ocena
0 / 5
Polubienia
32
Pobrania
73
Wydruki
1
Wyświetlenia
1909
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This was a request by some of my patrons

Printable surface is likely reduced a bit to 200(X)x225(Y)

Has be tested and working!

This replaces the "X CARRIAGE_TOOLHEAD/ENG-XC1_b.stl" piece 
Everything else on the original Ender NG Post HERE

Use heat inserts M3x4mm(L)x4.6mm(OD) or 5mm(OD)
4 on the front and 4 in the back.

The ApolloLander can be found on my patreon (with access to my discord where we can work out any kinks) or patreon shop page (which has a list of supported hotends)

You'd mix the ApolloLander Linear Rails Backplate, with the ApolloLander Wheels Main body

Tagi