1 / 5
"Ender 3 NG - coreXY" to ApolloLander (dual 5015 fans) interface ~ prototype — image 1
1 / 5

"Ender 3 NG - coreXY" to ApolloLander (dual 5015 fans) interface ~ prototype

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Single piece replacement (ApolloLander not included) Adds 4 mounting point matching an MGN12H pattern 20x20mm

Rating
0 / 5
Likes
32
Downloads
73
Makes
1
Views
1,912
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

This was a request by some of my patrons

Printable surface is likely reduced a bit to 200(X)x225(Y)

Has be tested and working!

This replaces the "X CARRIAGE_TOOLHEAD/ENG-XC1_b.stl" piece 
Everything else on the original Ender NG Post HERE

Use heat inserts M3x4mm(L)x4.6mm(OD) or 5mm(OD)
4 on the front and 4 in the back.

The ApolloLander can be found on my patreon (with access to my discord where we can work out any kinks) or patreon shop page (which has a list of supported hotends)

You'd mix the ApolloLander Linear Rails Backplate, with the ApolloLander Wheels Main body

Tags