Curtain rod holder system for 1"(One Inch) Rods
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a Curtain rod Holder system I designed in Fusion 360. It is designed to fit 1-inch Outer diameter curtain rods.
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 143
- Wydruki
- 1
- Wyświetlenia
- 564
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a Curtain rod Holder system I designed in Fusion 360. It is designed to fit 1-inch Outer diameter curtain rods.
I have been using these holders for several years in my home mostly without any issues. I recommend printing these with a minimum of 5 walls and 30% infill for better strength(remember more doesn't hurt). There have been occasions of them breaking during the curtains-changing process but that could mostly be attributed to improper handling. If you decide to use this system, make sure to print sufficient spares. I know the printing orientation isn't the best for the strength. But this is what I could come up with while making it look visually pleasing. It's strong enough for intended application as long as you don't put much load on your curtains(Pulling etc)
I have also included hole patterns for making/marking holes.
There are two types of holders.
Normal holders-For installing curtain rods on the same wall.
Axial holder-For installing the other end of the curtain rod in the opposite wall.