Wired Earbud Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Do you have a tangled mess of wired earbuds lying around? This is the solution. This is a wired earbud holder.
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 189
- Wydruki
- 4
- Wyświetlenia
- 951
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Do you have a tangled mess of wired earbuds lying around? This is the solution. This is a wired earbud holder.
Print Instructions
- Material: PLA or PETG
- Supports: No
- Orientation: Place the bottom flat on the build surface
Usage
All you have to do to use this earbud holder is placed the plug end of the earbuds into one of the larger slots on either the left or the right of the holder. Then wrap the earbuds around the holder until they do not go further. After that, the last step is to place the wire right below the earbuds into the smaller slots, on the top or the bottom of the holder. Depending on how you wound your earbuds, you may have to unwind them a little bit to get the earbuds secured into the smaller slots.
Tutorial
Remixing
If you would like to remix this model, the TinkerCAD file can be found here (or at https://www.tinkercad.com/things/bcp0Cuuy0Lu-earbud-holder?sharecode=rIwNhux-u8HhlzoTYZEMi82UrpNpat6dnRKl4w9KkEU).
If you enjoy this model, please leave a like and a comment. If you have any questions, concerns, or problems, please personally contact me.
If you want to support creation of more models like this one, you can subscribe to my Printables Club (at https://www.printables.com/@Devise3D#join:451) or you can purchase an individual model on CGtraitor (at https://www.cgtrader.com/devise3d).