CPAP hose and mouthpiece clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
CPAP clip for hanging hose and mouthpiece to dry.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 314
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Medical Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This clip is designed to fit over a glass shower wall so that you can hang your typical CPAP hose and mouthpiece while they are drying. It's small enough to easily slip into your CPAP case for travelling, and fast to print a replacements when you left the last one in your hotel room. For bonus points you can also use it at home, and print one for each bathroom!
Recommend to print flat using PETG or PLA at 0.15mm layer height, and to lightly sand or deburr the edge of the first layer. Supports not required.
The make shown in the images was printed using Prusament Transparent PETG. If you are travelling, I'd suggest printing with a bright or possibly even flourescent filament. This will make your clip more visible and less likely to be “forgotten” when rushing to check out.