1 / 2
BTT SKR Pico Mount for Ultimaker 2
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
You can mount a rspbery pi and BTT SKR Pico under the ultimaker 2 with existing holes.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 63
- Wydruki
- 0
- Wyświetlenia
- 1013
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Additional hardware:
- Two M3x10 : To fasten the mount to the ultimaker
- Four M2x10 : to fasten the pi to the mount and standoffs
- Four M2x? : to fasten the BTT board to the standoffs (already included with btt board)
Best way I found to use new BTT board with existing power supply is to utilize klipper and use BTT board as an auxilery board. I use the BTT board for the quite steppers and non-pt100 thermister.
Note: If you want to use a single power supply for both boards you will need to tap in to power traces from PCB which may not be safe.
Note: If you want to use a controllable heat sink fan you will need a 24V fan connected to BTT board instead of the 5V Ultimaker board fan.
Steps:
- Get klipper working with no hardware changes:
- once confirtable add btt board
- make changes to your printer.cfg configuration
- Added mine as reference
- make changes to your printer.cfg configuration