ATX Power Supply Bracket - Very Low for NR200/P
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An even *lower ATX PSU mount for the NR200/P case
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 72
- Wydruki
- 1
- Wyświetlenia
- 1625
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A lower ATX PSU bracket for the NR200P to allow both top fans (25mm thick) to be installed. Will be a tight fit using the included push-pin mounting but will work. I removed one side for TG/display purposes and removed the perforations on the back for installing the PSU facing the front (for intake).
Lots of caveats before using this so some base measurements to consider:
Max PSU depth: 140mm
Max GPU length: ~ 9.5in / 240mm
But you can likely install a deeper PSU if you have a shorter GPU….
…Or on my extreme case, fitting a short PSU (CX550-F RGB, 140mm) and a long GPU (Asus Strix 2070, 300mm). The GPU is just long enough not to cover the modular ports for the 24pin ATX/EPS12v/GPU (sata/molex modular ports are blocked). (see photo for result)
As with different parts, YMMV.