1 / 7

Friatec wall toiletflush buttons V2

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A new, two part design of replacement Friatec buttons for wall mounted flush. For easy print and reliability of use!

Aktualizacja u źródła: 5 paź 2023

Informacje o modelu

Model reveres designed from damaged buttons. Original springs are reused.

Design made for Friatec part no: 33 10 01

Print instructions:

adjust wall line count to chive strong upper brim 3 up to 5 ,
bottom thickens - min 4 layer for good quality of the presentation site,
print 6 hooks - use the same or different material to with well tuned flow rate - PLA is good for it springiness.

Assembly instruction:

hooks might to be chamfered with sharp blade to make the assembly easier,
a cleanup of hooks socket might be required - inspect the parts and have sharp blade ready ;)
just push the hooks into slots in buttons with firm pressure - they are dovetailed with relieve slot,
check the fitment of buttons with hooks in the panel. If hooks don't engage enough warm up the hook beam with a lighter and slightly bend it forward to adjust the engagement. See photo for smoke marks ;)
put the springs, put buttons and use!
dont't worry if central push rod will snap - this is a flaw it the front face mechanism design. Just keep the part inside the guide hole it will keep working.

This project is the update for: