Anycubic Chiron silicon feet mould
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mold to obtain 2 anti-vibration feet for Anycubic Chiron printer by casting silicone rubber
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 138
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I created this mold for the purpose of dampening the vibrations of the printer with silicone feet.
The silicone is two-component one with shore A 20. I think a shore A 10 is more effective.
There are two .stl files; one flat that requires removal of the stock rubber caps on the printer and one with the cap housing.
Printing suggestions are:
- Nozzle 0.6,
- Seam position: Rear,
- Avoid crossing perimeters-Max detour length 30mm,
- Perimeter generator: Arachne.
After printing, test the seal with water and, if necessary, seal with filler spray.
The feet on the left side are 0.5 cm lower than those on the right because the latter have to support the weight of the power supply. This measurement is purely empirical. Do your tests.
200 ml of silicone mixture is sufficient for a foot measuring approximately 3 cm