1 / 3
phillips, dzus tool keychain holds 50in lbs trq and can use a 11/16 socket to drive.
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Heat set a phillips bit in the end and heat set a dime in the other end
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 276
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
ok so one side is a heat set dime for using on dzus fasteners, and the other is a heat set phillips. I also added a key ring and when i tested it i had a failure at about 50 in lbs of trq.
you can also personalize this, like i have done in the past for trade show giveaways.
here is the link to the destructive test. i believe this was at 45% pla plus infill i also printed without supports.