1 / 3
phillips, dzus tool keychain holds 50in lbs trq and can use a 11/16 socket to drive.
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Heat set a phillips bit in the end and heat set a dime in the other end
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 20
- Makes
- 0
- Views
- 278
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
ok so one side is a heat set dime for using on dzus fasteners, and the other is a heat set phillips. I also added a key ring and when i tested it i had a failure at about 50 in lbs of trq.
you can also personalize this, like i have done in the past for trade show giveaways.
here is the link to the destructive test. i believe this was at 45% pla plus infill i also printed without supports.