1 / 7
BallBearing spool holder for (Un)orginal Prusa Drybox — zdjęcie 1
1 / 7

BallBearing spool holder for (Un)orginal Prusa Drybox

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Wstępna wycena dla PETG

4,16 € – 5,08 € netto (bez VAT)

Dla pliku: 10 Spool Carriers in Two Prints / spool-carrier-12.gcode

To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.

Plik i założenia wyceny

Plik użyty do wyceny

Średnia wycena orientacyjna: 4,62 € netto (środek widełek).

Masa podana przez autora
58 g
Czas druku podany przez autora
4,8 godz.
Materiał u źródła
PET
Materiał wyceny
PETG
Drukarka wyceny
Bambu Lab P1S - 0.4 nozzle
Proces wyceny
0.20mm Standard

Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.

Zapisane na tym urządzeniu.

Ball Bearing Spool Holder - less friction, more fun.

Ocena
4,87 / 5
Polubienia
110
Pobrania
615
Wydruki
26
Wyświetlenia
2082
Oceny
23

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I didn't like the friction of the steel bars, it was kinda hard to spin the spool even by hand..
So here is my mod: ball bearing spool holder for (un)Orginal Prusa Drybox.

The mount holes are for original, 18mm, bars.
There is a version for 20mm bars - "WALL_beam_20mm.stl

PRINT:
For one spool you need to print 4x PIN.stl, and 4x WALL.stl 
(Total for 5 spools: 20 pins, 20 walls)


BUY:
For one spool you need 4x ball bearings 608, 
(Total for 5 spools: 20 bearings)

Any 608 will work (608, 608z, 608zz, 608rs …).

For best experience, add this one too: https://www.printables.com/model/624410-ptfe-converter-6-to-5-spools-for-unorginal-prusa-d

 

 

 

V2: Added second version after battle-testing this model

v2 is more sturdy, distance between bearings is bigger, so the spool sits better “in the saddle”, this fixes the issue with very lightweight spools with not much filament left, that sometimes were pulled out of berings when nearing end of spool. Also the hole for steel bar is bigger, from 18.30mm to 18.50mm

 

On my V2 prints you can see embedded numbers for spools, this makes it easier to see which holders relate to which spool, thats usefull when you take out everything from inside of dry-box, and you start to re-fill whoole box. Thoose are made with “add negative part→ text” in slicer, example one is available as .3mf

 

 

PS: There exist a remix, that uses m3 screws to secure parts, you can use that if you're paranoid ;)