Sovol SV06 Filament Guide
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a filament guide system for between drier boxes and an SV06.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 663
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This is a filament guide kit for between drier boxes and an SV06. I have the Sovol dual roll drier placed between both of my SV06 printers. In order for it to feed without binding I have to make a PTFE tube filament guide.
Print the Nut and Insert at a fine layer height (I did .15mm).
The SV06 Tube Guide bracket that mounts to the top of the frame requires no supports and uses the same factory screws as the spool holder.
Enlarge the feeder hole(s) in your drier box to 31/64" (12.2mm) for the insert part to fit correctly.
I recommend threading the insert and nut together with a couple wrenches to clean up the threads so you can hand tighten them when installing on the box.
You will need whatever length of 4mm OD/3mm ID tube that is required for you to have a path that does not have a tight turn out of the box and allows you to open the box with out binding. I recommend the 3mm ID for ease of filament movement. I tried 2-2.5 and it was under extruding due to friction.
The shelf mount for the tube I find keeps the pathway straight with a nice radius for the filament path.