Updated 8/2/25: OM System / Olympus Tough TG Ring Cap + Lens Hood (several styles)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use this to protect and shade your TG-7 or other TG series camera's lens, or as a base to make other accessories.
- Ocena
- 5 / 5
- Polubienia
- 18
- Pobrania
- 212
- Wydruki
- 1
- Wyświetlenia
- 1838
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Update 8/2/2025:
After using this for several months and feeling like it looked slightly off, I re-measured and discovered that the rotation was off by about 1 degree 🤦.
I've uploaded version 0 2 9 .stl's and blender files here which fix that. There is no change to the hood insert pieces and the ring-only versions (which don't have notches for the hood insert).
---
This is a replacement for the accessory ring cap that comes on the OM System TG-7, and other Olympus TG series cameras*.
There are several styles here, including some hood and ‘hood insert’ options which are intended to shade and further protect the lens.
The ‘hood insert’ versions slot into the notches on the ring cap, so you can make the hood part a different color. They won't work with the ‘ring only’ variants of the ring.
The ‘slim outer edge’ versions are slimmer and feel nicer IMO but might be harder to print and more difficult to remove from the camera.
I suggest printing the ring parts with the front part down (as it's oriented in the stl) with 0.15mm layer height. They should be fine without supports.
*⚠ Important note: I have only personally tested on the TG-7, and one person has posted a make using this on a TG-4. It should work on other TG series cameras, but I haven't been able to test. Post a make or leave a comment if you're able to try it!