1 / 4
IKEA Legitim and 365 Cutting Board Holder and Drying Rack — zdjęcie 1
1 / 4

IKEA Legitim and 365 Cutting Board Holder and Drying Rack

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Designed to store up to nine IKEA cutting boards (three Legitim 34x24 and six 365+ 22x16). Doubles as a drying rack.

Ocena
0 / 5
Polubienia
8
Pobrania
71
Wydruki
1
Wyświetlenia
530
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial

Cutting board holder, designed to be placed in a corner of a drawer or in other similar places.

Can hold up to nine IKEA cutting boards:

  • three “Legitim” 34x24 cm
  • two sets (six in total) “365+” 22x16 cm

The fit is intended to be a little bit loose (but not TOO loose), to allow the cutting boards to slide in and out easily when you grab them.

The bottom part has drain grooves, so it can double as a dry rack.

Printing advices

The model has multiple 80mm bridges. Before printing do a bridge test and check if your printer can handle that. If in doubt, use supports.

I printed mine in regular PETG at 120 mm/s and 0.4 layer height, using a brim but without supports. As you can see from the pictures it looks a bit rough, but is dimensionally accurate and also plenty strong for its purposes. So do yourself a favor and save some time and filament, no need for ExtraFine profiles here.

Tagi