Clorox ToiletWand Storage Caddy Insert
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This insert holds the stack of pads securely so they do not move around.
- Ocena
- 3 / 5
- Polubienia
- 18
- Pobrania
- 74
- Wydruki
- 1
- Wyświetlenia
- 486
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial
I didn't like how the pads weren't very constrained in the caddy and it made it a bit harder to load a new one on the wand, so I made this to fill in that extra space.
This is intended to be printed in vase mode with .9mm of bottom layers. I used a perimeter width of .7mm. You can do this with a .45 nozzle just fine but the one printed here was done with a .6 nozzle. Alternatively you could do 2 perimeters of .4 and that will just take longer.
I printed using .3 layers, .7 perimeter width at 60mm/s and it took about 2.5 hours and 102 g of PLA.
This has clearance features to avoid the clips that attach the handle holder to the caddy. Just make sure it is put in the right direction.