1 / 1
I+T Beam Jigs for HDX Tote 102L / 45L Garage Ceiling Railing
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Jigs for constructing I + T beams for HDX Tote ceiling storage solutions.
- Ocena
- 0 / 5
- Polubienia
- 27
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 1056
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (34)Powiązane
Constructing these I/T beams can be tricky as sometimes lumber is warped a little bit. These jigs can be used to ensure the beams are always in the right place as you construct them.
Instructions for using this jig:
- Fit the boards into the jig on on end
- Slide the jig down about 8 inches
- Drill the first pilot hole using a bit that is the length of the joining screws you have selected (smaller in diameter than the threads)
- Install the first screw
- Flip the boards over and repeat steps 3-4
- Move the jig down 1 foot and repeat steps 3-5
- Rinse repeat