Mounting Bracket for XDM1241/XDM1041
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount your OWON XDM1x41 under a shelf at your workbench to prevent it from pivoting while being operated.
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 93
- Wydruki
- 1
- Wyświetlenia
- 655
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The OWON XDM1241, being a budget bench multimeter, is quite a neat little unit for the hobbyist. Its small form factor certainly is a plus if you don't have a lot of bench space available.
The downside of it being such a compact and light device is, however, that it tends to slide around on your bench if you do not hold in place while pushing buttons or plugging in test leads.
Therefore, I designed this bracket to be able to attach the meter to a shelf board (from below). It does not require any modifications to the device but holds it firmly in place nevertheless.
To attach the bracket simply slide it in from the bottom right behind the front bezel (see also the picture), with the indentations for the rubber feet pointing to the rear of the multimeter. Then mount the bracket to e.g. a shelf board using two screws while holding the bracket flush with the sides of the meter.
Print Settings
Printer:
Flying Bear Ghost 4
Rafts:
No
Supports:
No
Resolution:
0.3 mm
Infill:
30%
Filament:
PLA