Cylinder for the Rekt Jury Blaster

I modelled a replacement cylinder for the Rekt Jury.

You will need to print the cylinder open end down with organic supports ( I use automatic painting). The nub does not need supports.

You will also need a 25mm m3 pan head screw (hex head won't work as the head is too big)
Approx 8mm of 5mm diameter spring (anything that fits over the screw really).

There is a slot inside the nub so you can hold it still while screwing from the back. Only screw it until it is flush with the face.

I welcome feedback as I am still improving this model. I often wondered if a 3D printed cylinder would work and it appears it does :-). Time will tell how long the rotation nubs last on the back of the cylinder but they seem fine so far.

Update 2 (11/01/24):

I updated the cylinder again because sometimes it failed to rotate fully and click in position. This now looks to be resolved.

Update:

I added a new cylinder file. This one has much bigger chamfers on the dart holes for better location and fractionally bigger rotation nubs to rotate the cylinder a touch further which helps when you pull the trigger really slowly.