1 / 3
Leap Motion Controller 2 GoPro Mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
GoPro mount for the Leap Motion Controller 2, tooless assembly
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 179
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
Versions:
- There are two versions, A and B. Depending on the printer and the filament you are using, a version may work better than another, but they both function the same.
- Version A:
- Recommended to print with 100% infill, without suport
- Includes zip-tie tie down point for cable strain relief
- Ambidextrous, you can choose which side the cable comes out
- Easier to install, but holds the controller less securely, might dislodge during excessive active movements
- Assembly:
- Version B:
- Recommended to print with 100% infill, with suport
- Includes zip-tie tie down point for cable strain relief
- Ambidextrous, you can choose which side the cable comes out
- Holds the controller more securely, but requires a bit more force and dexterity to install.
- Assembly:
Mounting:
- The mount can be mounted to any GoPro mounts that have three prongs.
- If you wish to wear the Leap Motion controller on your neck, you can check out the GoPro neck mounts I published:
- If you wish to mount the Leap Motion controller on a mic arm, you can check out the GoPro mic arm mount I published: