1 / 3
Leap Motion Controller 2 GoPro Mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
GoPro mount for the Leap Motion Controller 2, tooless assembly
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 45
- Makes
- 0
- Views
- 179
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Share Alike
Versions:
- There are two versions, A and B. Depending on the printer and the filament you are using, a version may work better than another, but they both function the same.
- Version A:
- Recommended to print with 100% infill, without suport
- Includes zip-tie tie down point for cable strain relief
- Ambidextrous, you can choose which side the cable comes out
- Easier to install, but holds the controller less securely, might dislodge during excessive active movements
- Assembly:
- Version B:
- Recommended to print with 100% infill, with suport
- Includes zip-tie tie down point for cable strain relief
- Ambidextrous, you can choose which side the cable comes out
- Holds the controller more securely, but requires a bit more force and dexterity to install.
- Assembly:
Mounting:
- The mount can be mounted to any GoPro mounts that have three prongs.
- If you wish to wear the Leap Motion controller on your neck, you can check out the GoPro neck mounts I published:
- If you wish to mount the Leap Motion controller on a mic arm, you can check out the GoPro mic arm mount I published: