Tarmo5 Wheel and Tyre Set
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Set of printable wheels and tyres for the Tarmo5 RC car by Engineering Nonsense
- Ocena
- 5 / 5
- Polubienia
- 17
- Pobrania
- 195
- Wydruki
- 1
- Wyświetlenia
- 932
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I created a set of wheels and tyres, as I couldn't find any locally that would fit.
Wheels have the hexagon shape indented for the drive shaft of the Tarmo5 with a 4.5mm hole to take the 4mm screw easily. I had to use a 1mm shim on the edge of the drive shaft to get this to fit nicely.
Wheels are in 2 sizes
- Front being 77mm diameter, 28mm wide. Takes the 26mm wide tyre
- Rear being 77mm diameter, 43mm wide. Takes the 41mm wide tyre
There is a 2mm lip on the outer edge of the wheel to stop tyre sliding off
Wheels printed in PLA and PETG, I found the PETG more forgiving. I used 30% infill for the spokes/hub area to ensure optimal strength to weight
Tyres printed in TPU with 10% infill to allow a bit of spring. Spikes added to tyre to give better grip. I did test with a standard tread but found these spikes did the job best. Please note, they will mark a wood floor so don't destroy your hallway flooring with this!
All designed to print without any supports