Vibration-dampening squash ball feet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Vibration-dampening feet that attach to the frame of the MK3/MK4 without increasing the height of the printer.
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 46
- Wydruki
- 1
- Wyświetlenia
- 351
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Vibration-dampening feet for the MK3/MK4. Uses 4x double yellow dot squash balls.
I wanted to make a version that does not add height to the printer to make it easier to fit into various enclosures.
The design is inspired by several other designs on Printables and Thingiverse.
Printed on Prusa MK4
Nozzle: 0.4mm
Layer height: 0.2mm
Outer shells: 3
The noise from my MK4 is now significantly reduced.
The front feet are mounted on the outside of the frame, and the back feet are mounted on the inside.
Print the nut holder sideways to avoid the need for support.
For this build, you need the following (except the prints)
- 4x squash balls (double yellow dot)
- 4x M4 nuts
- 4x M4 screws 12mm (10mm should work fine too)
The nut fits tightly in the print. Some force (pliers) might be needed to get them in place. You can also use pliers when inserting the holders into the bottom of the frame to turn them 90 degrees.
The squash balls also fit very tightly. Use a rolling movement to press the squash ball into its holder.
Don't over-tighten the screws!