Voron Trident Auxillary Fan Spacer & Duct
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 9mm spacer and duct piece for the Voron Auxilliary Fan by JackJack3231
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 775
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
I did not really want to bother with removing my XY endstop pod until I fully commit to CANBUS.
Print the ‘Ever so slightly smaller duct’ and use the spacer that goes under the fan bottom part. This leaves about 2-3mm of clearance to the pod, you will need M5x16mm screws due to the extra height.
I was in a rush, and messed up the measurement of the duct, I have had this printed sitting around for a while now and just wanted to get it installed.
I am using the LDO 300mm kit, so the duct is scaled accordingly.
Tested and is working as intended, although not the best solution there is a significant improvement with my PLA prints!
EDIT 16/10/2023
I have now uploaded the ‘Duct of correct size’ to make up for my shortfall. It is now even closer to the pod!
Untested, but scale along the Z-Axis only as you see fit.