1 / 3
Voron Trident Auxillary Fan Spacer & Duct — image 1
1 / 3

Voron Trident Auxillary Fan Spacer & Duct

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A 9mm spacer and duct piece for the Voron Auxilliary Fan by JackJack3231

Rating
0 / 5
Likes
9
Downloads
41
Makes
0
Views
775
Reviews
0

Updated at source:

Model information

License
GNU General Public License v3.0

I did not really want to bother with removing my XY endstop pod until I fully commit to CANBUS.

Print the ‘Ever so slightly smaller duct’ and use the spacer that goes under the fan bottom part. This leaves about 2-3mm of clearance to the pod, you will need M5x16mm screws due to the extra height.

I was in a rush, and messed up the measurement of the duct, I have had this printed sitting around for a while now and just wanted to get it installed.

I am using the LDO 300mm kit, so the duct is scaled accordingly.

Tested and is working as intended, although not the best solution there is a significant improvement with my PLA prints!

EDIT 16/10/2023

I have now uploaded the ‘Duct of correct size’ to make up for my shortfall. It is now even closer to the pod! 

Untested, but scale along the Z-Axis only as you see fit.