RepRack rod clamp M3 remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of the rod clamp of RepRack version to tighten using M3 screw and nut
- Ocena
- 5 / 5
- Polubienia
- 41
- Pobrania
- 240
- Wydruki
- 4
- Wyświetlenia
- 1205
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
If my understanding is correct, the original rod clamp is designed to let screws dig into the rod itself, which does not apply well to steel rods. So I made this version that tightens its grip using a 10mm M3 screw and hex nut.
My build is not yet complete, but the 25mm wardrobe rod is already a very tight fit, and little tightening is necessary.
I apologize to the original creator of RepRack for not including their logo onto this design, that was simply out of scope.
Also inspired by https://www.printables.com/model/528265-reprack-streamlined-clamps
Print with 7 perimeters 0.3mm layer height and without support in PETG.
Update: added remix of the original 19mm (¾") version as well. I have not printed this.