RepRack rod clamp M3 remix
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix of the rod clamp of RepRack version to tighten using M3 screw and nut
- Rating
- 5 / 5
- Likes
- 41
- Downloads
- 240
- Makes
- 4
- Views
- 1,205
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Share Alike
If my understanding is correct, the original rod clamp is designed to let screws dig into the rod itself, which does not apply well to steel rods. So I made this version that tightens its grip using a 10mm M3 screw and hex nut.
My build is not yet complete, but the 25mm wardrobe rod is already a very tight fit, and little tightening is necessary.
I apologize to the original creator of RepRack for not including their logo onto this design, that was simply out of scope.
Also inspired by https://www.printables.com/model/528265-reprack-streamlined-clamps
Print with 7 perimeters 0.3mm layer height and without support in PETG.
Update: added remix of the original 19mm (¾") version as well. I have not printed this.