Sony Alpha a6400 LCD Sun Hood
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple LCD sun hood for Sony Alpha a6400
- Ocena
- 0 / 5
- Polubienia
- 48
- Pobrania
- 161
- Wydruki
- 0
- Wyświetlenia
- 1980
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I had some shooting to do on a sunny day the next day and had no external monitor to help me. Spent the sunday (irony?) designing and printing this sun hood. It fits the LCD screen with a elastic band from behind. Here is a rought guide on how to assemble it.
Beside the printed parts you will also need…
About 10cm of a 20mm elastic band. ( I salvaged mine from a old respirator). About 15cm of a 3mm leather strip (or any other soft material like eva. this will protect the camera LCD from scratch)
Its a good measure to sand the inside of all four plates. If your print is shiny, specially if you print with PLA, this will prevent some undesired glare from outside or from the LCD screen.
Clean the parts after sanding.
Glue the leather strip with CA glue to the back of the back plate. Its the part with the little tab. (This piece is a little diferent from the stl file because was a previous iteration)
Run the elastic band trough the slits on the back plate from the back, like so. Dont pull it too tight. It need to have some slack. Remember the back of the back plate is the side with the tab. Reserve.
Glue the main parts with CA glue. The little tabs will make it easier to align the borders. Gluing everything upright against a surface, like in the picture, will help you keep all four parts aligned to each other. This is important! And be careful to not glue the parts to the table.
Now you can glue the back plate to the main assemble. The tips of the elastic band should go on the inside. Glue the tip of the elastic band with CA glue to the inside of the side plates, over the strips and spikes.
Glue the band covers over the elastic band. Use CA glue on the borders and on the inside. This will give extra grip to the fix.
That's it! Slide the sun hood from the bottom taking care for the tab not scratch the screen. You can glue some soft material strip there if you want to.
I dont know if this would be compatible to any other camera models.
I can provide the fusion 360 files if anyone want to make some adjustments on derivations.
=======================
Printed on a custom graber i3 with black ABS with draft setting from Cura with a 0.4 nozzle.
Print took about 5 hour total because my printer is slow as s#$%.