SCX24 Bronco Tow Hitch & Receiver
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Glue-on receiver & hitch for Axial SCX24 Bronco
- Ocena
- 5 / 5
- Polubienia
- 43
- Pobrania
- 284
- Wydruki
- 0
- Wyświetlenia
- 1640
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed this receiver hitch to be super glued onto the bottom of the SCX24 Bronco rear bumper. The drop hitch is removable for clearance when you aren't towing. The receiver profile matches the bumper as much as possible to reduce clearance issues.
It's intended for light duty since the bumper and bumper mount flex are structural limitations. A more “Heavy duty” design would mount direct to the frame rails, but would eliminate the body pivot function (which is necessary for battery access).
It was designed for fun, not any particular trailer, just to be a tow point my son for various other toys, vehicles, & implements (works great with Bruder John Deere Dump Trailer below).
Printing:
Printed in Overture PETG @ 0.2 layer, 100% infill.
Hardware required:
- qty 1: M2x4 cap screw to retain the hitch
- qty 1: 4.8mm ball stud for the hitch ball (could use M2 cap screw if you prefer) (like this)
Assembly:
- Remove bumper & clean surface well with IPA or other degreaser
- Super glue receiver in position.
- Assemble ball stud (or cap screw) to hitch.
- Use M2 cap screw to secure hitch.
- Tow stuff around your living room.
- Enjoy!