Ender-3 S1/Ender 3-S1 Pro Adapter for the Universal Enclosure (REQUIRES DRILLING THROUGH PLEXIGLASS)

This is a pretty involved modification, so be warned beforehand! A video tutorial will be released soon - a link will be provided here in the description once its available!

Tools Required:

• Power Drill
• 1/4 inch bit
• 1/8 inch bit (or similar)
• Eye Protection
• Masking Tape
• Scissors
• Needle Nose Pliers
• x4 nuts from Universal Enclosure spares
• x4 bolts from Universal Enclosure spares
• Allen wrench from Universal Enclosure

• Start by printing off all of the parts & templates
• Cover the plexiglass for CABLE CUBBY TEMPLATE 1 and POWER CABLE TEMPLATE 1 with masking tape on BOTH sides of the back panel of plexiglass 
  • PLEASE MAKE SURE THAT THIS IS ON THE BOTTOM OF THE BACK PANEL

• After adding the tape, place the CABLE CUBBY TEMPLATE 1 into position and add a nut and bolt through the existing hole in the plexiglass

• Using the power drill, create pilot holes using the smaller bit (1/8 inch or similar) in the 2 holes in the center of the rectangular pattern. After the pilot holes, expand the holes using the 1/4inch bit and add a nut and bolt to each

• Next, add pilot holes to all of the perimeter holes and then expand the hole with the larger bit. 
• Exchange CABLE CUBBY TEMPLATE 1 with CABLE CUBBY TEMPLATE 2 and ancho into position using the 2 bolts and nuts in the center of the rectanglular pattern

• Repeat the process of drilling the holes, starting with the holes nearest to the edge of the acrylic
• Remove CABLE CUBBY TEMPLATE 2 - if the cutout is still attached to the plexiglass, carefully break any remaining acrylic bridges with the needle nose pliers
• Repeat the process for the POWER CABLE TEMPLATE 1 and POWER CABLE TEMPLATE 2 anchoring in place with the center hole with a bolt and nut

• Add the CABLE CUBBY MAIN and CABLE CUBBY BACK RIM to the back panel using 4 nuts and 4 bolts

• Add the back panel plexiglass to the Universal Enclosure and place the Universal Enclosure on a table where you can allow a corner to hang off of the ledge
• To install the power cable parts, disconnect the power cable from the Ender 
• Run the power cable through the plexiglass prior to installing the POWER CABLE prints
• Add the POWER CABLE WASHER to the inside of the enclosure by placing it around the power cable on the inside of the enclosure
• Place the two POWER CABLE SLEEVE parts around the power cable on the outside of the enclosure 
• Thread the pieces together with the power cable running between the parts

• Add the Ender-3 S1 to the enclosure - DONE!